Algocraft

WriteNow!

Universal in-system programmer with up to 8 sites programmed truly in parallel, and up to 32 channels with demultiplexer modules. Compact and easy to integrate into ATE and fixtures; it runs standalone or under host control.

Algocraft WriteNow! 8-site in-system programmer
  • 8sites programmed at once
  • 32channels with demultiplexer modules
  • ISO 26262certified by a third-party lab, for automotive functional safety projects

Where it sits on the line

ATE / PCSends commands over RS-232, USB or LAN
WriteNow! 8In the fixture, 8 programming sites
Panel × 8 PCBsOne board programmed on each site

Firmware, board parameters and the programming flow are all stored in the programmer, so the host starts programming with a single command; it can also run standalone through the isolated low-level interface.

Specifications

Programming sites1, 2, 4 or 8, truly parallel (WN-PRG01A / 02A / 04A / 08A)
Channel expansionUp to 4 demultiplexer modules stacked on each ISP connector; up to 32 channels on WN-PRG08A
Supported device typesMicrocontrollers, serial memories, parallel memories, CPLDs and other programmable devices
ProtocolsJTAG, SWD, UART, SPI/QSPI, BDM, SWIM, I2C, DAP, cJTAG, C2, ICSP, PDI, UPDI, SBW and more
Programmable power supply1.5–15 V output
I/O voltageProgrammable, 1.6–5.5 V
InterfaceUSB, LAN (isolated), RS-232 (isolated)
Standalone operationLow-level control interface (isolated)
Relay isolationBuilt into the ISP I/O on the single-site model; optional relay isolation module for the other models
Power15–24 V wide range
Functional safetyCertified by a third-party lab as compliant with ISO 26262 and IEC 61508