Where probes cannot reach, boundary scan can.

Boundary scan (JTAG) checks the connections on a board through test circuitry built into the chips, with no physical probes. Solder joints under BGAs and nets on dense boards are covered without adding fixture cost.

Advantages in production

  • No extra probes or fixtures

    Nets under BGAs and on dense boards are tested without test points, so the fixture stays simple.

  • Ready before the first boards arrive

    Tests are generated from design data, so they are ready before the boards come back.

  • Faults located to the pin

    Results point to the exact net and pin, so repair is no longer guesswork.

Long-term value

  • Coverage holds as boards get denser

    Parts shrink and test points disappear, yet fault coverage stays where it was.

  • Shorter repair time

    Pin-level diagnosis lets the repair station find the fault faster and scrap less.

  • One test port for the whole life

    The same JTAG port serves prototype debug, production test and repair.

How we help

Pre-sales
Programming and test solutions for your project, demos, fixtures and system integration.
After-sales
Commissioning, training, on-site support, custom drivers and algorithms.
Consulting
Line planning and test process optimisation.

Resources

  • Application notes
  • Case studies