User management, per-command permissions, programming cycle limits and firmware encryption can all be configured directly in the Workbench.
Information security has become a critical issue in today’s technology landscape, especially in industries such as automotive electronics where in-system programming (ISP) is widely used. This article explains how to actually enable security features in FlashRunner Workbench.
Enabling user management
Workbench, the FlashRunner user interface, has a dedicated Cyber Security section. Enter a password and click Set new password to enable user management mode. Be sure to remember this password, as you will need it every time you log in as Admin.
Two account types are available: Admin and Guest.
To disable user management mode, click Remove password and enter the Admin password.
Per-command permissions
Through the permission manager, the Admin account sets which commands each type of user can execute. Each command can be set to one of four options:
- Guest — the command can be executed by both Guest and Admin.
- Admin — only Admin can execute the command.
- Prot — a password must be entered before the command is executed.
- None — the command is blocked and no user can execute it.
Programming cycle limits and firmware encryption
Flashing Cycles Limitation Management is configured after logging in as Admin, and sets the maximum number of programming cycles that can be run in Guest mode.
Firmware Encryption is always available directly in the Workbench. It encrypts the firmware before it is programmed into the device, protecting the intellectual property it contains.